2.4 Indicator & Enclosure


There are five indicators on the EZR34-012 router.

  1. On the left side of the green-color cooler fin, there are System and WiFi indicators.

  2. On the left upper corner of the SIM slots, there are SIM#1 indicators.

  3. LAN & WAN indicators are on the RJ45 socket. The left side is the WAN port, and the right side is the LAN port.






This light indicates that the router is receiving power. If it's lit solid green, then the router has booted successfully.


The router system is booting up. The system indicator flashes while resetting or flashing the firmware.


No light at all indicates that the router is not receiving power. Check the PoE socket connect to the motherboard and check the PoE adapter. You might need to test an alternate power socket if the router doesn't power on.



This light indicates that the modem is sending a Wi-Fi signal. If the light is on the green, you can see and connect to the Wi-Fi network.


If you are connected to the Wi-Fi hotspot, it will flash green to indicate data going to and from the router. If the router is connected to another Wi-Fi hotspot (Wi-Fi relay), it will also flash because it has the data flow.


If it's off, your router is no longer sending a Wi-Fi signal. You can log in to the router admin and turn on the Wi-Fi master hotspot.



These lights indicate the router is using which SIM card. Please use SIM#1 slot on EZR34-012 CAT12 router.

Close the Enclosure

Close the lid & press it with your hand. Then use the hexagon end on T-wrench to tighten four pieces of bolts on the lid. After closing the enclosure, please review and ensure no gap after tightening the screws!

Last updated